null
Mikuni

Mikuni RS38 Carb Kit | Suzuki GSFS Bandit 2000 & Later | Mikuni Carburetor Kit

(No reviews yet) Write a Review
SKU:
SMC-RS38GSFS-1
MPN:
SMCRS38GSFS
  • Mikuni RS38 Carb Kit | Suzuki GSFS Bandit 2000 & Later | Mikuni Carburetor Kit
  • Mikuni RS38 Carb Kit | Suzuki GSFS Bandit 2000 & Later | Mikuni Carburetor Kit
  • Mikuni RS38 Carb Kit | Suzuki GSFS Bandit 2000 & Later | Mikuni Carburetor Kit
  • Mikuni RS38 Carb Kit | Suzuki GSFS Bandit 2000 & Later | Mikuni Carburetor Kit
$1,299.00

Description

 This Mikuni RS38 carburetor Kit is for direct fitment to most Larger GSFS Bandit engines. They will breathe a whole new lease of life into your machine with an up to 25% increase in power, whilst making it perform and operate as it should with no hesitations or flat spots.

You will very quickly realize that the expense of a rebuild of your old worn OEM carbs can far exceed the cost of these new units and unfortunately as with many rebuilds now days you only have the option in many cases of gambling with very poor quality aftermarket parts. Considering this and if intending to ride and enjoy your motorcycle it makes good sense to retire your OEM carbs into the cupboard and step up to a set of RS’s.

Before rushing in and ordering please firstly check your carb spacing and carbie sizes for compatibility. These are not suited for downdraft engines.

This Mikuni kit comes with the carb  throttle port  center to center spacing’s listed below for direct fitment to 2000 and Later Suzuki GSFS Bandit Engines.

A= 82mm (spacing center to center between carb 1 & 2)
B= 85mm (carb 2 & 3)
C= 82mm (carb 3 & 4)

Requires the use of pre 2000 Intakes ( Included in kit ) 

The carb total front to back length of 100 replaces your OEM carbs measuring 95 thru 100mm and comes with either a 55mm inlet outside diameter for use with POD filters or velocity stacks or with fitted sleeves increasing the inlet diameter to 58mm for standard air-box compatibility. The carb outlet diameter at the motor end is 42mm, where the RS 38 and 36’s are an exact match to your OEM 42mm.

Some later model Bandits have a throttle position sensor on the OEM carbs, where if wont run with it disconnected you will need to purchase elsewhere a Dyna S ignition system which eliminates the sensor and also offer some other performance enhancements.

Pilot Jet: VM28/486-17.5, Needle: 9CHY3, Needle Jet: Y-6 (568 Series), Main Jet: N100.604-135

 Your stock throttle cables will match to these carbs, where we also have available in the RS accessories page either our road bike throttle and cable assembly (KRS-001) or a Quick action 1/4 turn throttle and cable kit (PPQA40K)
You can also buy separately either POD filters or Velocity stacks which have no form of filter in them (15, 30,50 and 75mm long) for racing.

View AllClose

0 Reviews

View AllClose