Yamaha XS500 Electronic igntion Instructions

Remove the ignition cover
Make LF Mark
Remove OEM Rotor
Remove OEM Rotor and Plate- points and Condenser
Install new Rotor
Institute New Plate Assembly
Ensure electronic ignition of orange wire (letter T, Tytronic) points to black magnet
Rotate Rotor 180 degrees if not
Tighten Plate
Connect Orange and Grey Wire
Connect Red wire to Brown Wire (12v switched)
Do not connect Red wire to Coils
Make sure all wires are correct before starting
Start Bike
All ignitions tested before shipping
XS500 electronic ignition works
Must Have 3 OHM Coils

Built-in current protection circuit. Only 3 wires, built-in Led Timing light, no other parts, easy to install. Computer program controls advance angle and timing.

Specifications

  1. Start of Spark Advance:1400 rpm
  2. Full Advance: 3950 rpm
  3. Made By TyTronic for SMC!
  4. Advance Range: 5-37 angle

Tytronic Built:

This electronic ignition is designed and produced by Tytronic,duty cycle is designed at 50%. In every ignition when ignition first senses the signal,ignition will turn on automatically then supply power to the ignition coil. When it senses the second signal this will trigger coil to ignite.This is the complete ignition process. The duty cycle of the original bike is about 50%,and some ignitions you can buy in the market are about 95%. Too big or too small of a value the ignition system energy you will experience insufficient spark and poor performance.

Mar 1st 2024 Dave Electric

Recent Posts